Wagner Spray Tech Recalls Heat Guns Due to Fire and Burn Hazards
CPSC recall 09243 · announced June 17, 2009 · Wagner Spray Tech · 300,000 units affected
The product
The recalled heat guns emit hot air and are used for paint and flooring removal, defrosting freezers and water lines, bending plastic, hobbies, etc. Recalled models include the Milwaukee Heat Gun MHT3300, ACE HT3500 Heat Gun, and the Wagner Heat Gun HT3500 with date codes V300R through Z365R and A001R through A111R. The heat gun's name and model number are located on a black label on the bottom of the heat gun's barrel. The date code is stamped into the bottom of the handle near the power cord. The heat guns are black or yellow plastic and measure about 10 inches long, 8 inches high and 3 inches wide.
The hazard
An electrical component failure inside the heat guns can cause them to continue to produce heat after the power switch is turned off. This can melt the heat gun's plastic exterior, causing a burn if the heat gun is touched and ignite nearby combustibles, posing fire and burn hazards.
What to do (per CPSC)
Consumers should immediately stop using the recalled heat guns and contact Wagner for a free replacement product.
Notes
Incidents (per CPSC): The firm has received nine reports of the heat guns overheating. No injuries or property damage have been reported.
Sold at: Major and independent hardware and home improvement stores nationwide from November 2004 through April 2009 for about $40.
Consumer contact: For additional information, contact Wagner toll-free at (888) 925-6244 between 8 a.m. and 4:30 p.m. CT Monday through Friday, or visit the firm's Web site at www.wagnerspraytech.com
Source: U.S. Consumer Product Safety Commission public recall data. This page reports official records and is not legal, medical, or repair advice.