1995 International Harvester 8200 Recalls

3 known recalls on record with NHTSA. Data updated 3 hours ago.

Service Brakes, Hydraulic:foundation Components:hoses, Lines/piping, And Fittings

August 2, 1995 Campaign 95V144000 278 units

THESE VEHICLES WERE BUILT WITH AN IMPROPERLY PLUMBED BRAKE SYSTEM WHICH AFFECTS THE BRAKING ON THE REAR AXLE WHEN RUNNING EITHER BOBTAIL OR PULLING A TRAILER.

Full recall details: the risk and what to do →

Steering:linkages:tie Rod Assembly

May 9, 1995 Campaign 95E009002 196 units Aftermarket / equipment part

DURING ASSEMBLY, THE TIE ROD END NUTS WERE NOT PROPERLY TORQUED. EXTREMELY LOW TORQUE CAN ALLOW MOVEMENT BEWEEN THE BALL STUD AND THE TIE ROD ARM CAUSING DAMAGE.

Full recall details: the risk and what to do →

Vehicle Speed Control:accelerator Pedal

October 7, 1994 Campaign 94V196000 6,449 units

THE BASE OF THE ELECTRONIC ACCELERATOR PEDAL IS MADE OF DIE CAST ALUMINUM. THE BASE MOUNTS DIRECTLY TO THE CAB FIREWALL. THE CAB FIREWALL IS NOT RIGID ENOUGH OR FLAT ENOUGH AT…

Full recall details: the risk and what to do →

Source: National Highway Traffic Safety Administration public recall data. This page reports official records and is not legal or repair advice.